Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Stress criterion for brittle material

Carmelo B. IJCLab/Université Paris-Saclay

Please login with a confirmed email address before reporting spam

Hello everyone

I am going to simulate the thermal expansion of a mirror. Could you tell me what is the suggested criterion to evaluate the stress in the mirror?

As far as I know, von Mises is widely used for ductile materials.

Best regards.


3 Replies Last Post Oct 22, 2020, 2:36 a.m. EDT
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 4 years ago Oct 19, 2020, 7:42 a.m. EDT

I do not think that there is an universal answer to your question, but largest principal stress (solid.sp1) is a more common criterion for brittle materials.

-------------------
Henrik Sönnerlind
COMSOL
I do not think that there is an universal answer to your question, but largest principal stress (solid.sp1) is a more common criterion for brittle materials.

Carmelo B. IJCLab/Université Paris-Saclay

Please login with a confirmed email address before reporting spam

Posted: 4 years ago Oct 21, 2020, 1:26 p.m. EDT

Dear Henrik Sönnerlind, Thank you for your message. I will take a look so on principal stress criterion. In your opinion, can I related the principal stress criterion with the Rankine fracture criterion? Indeed a crack initiates when the maximum principal stress reaches the material strength.

So I was thinking to calculate all principal stresses (x,y, and z) in glass and if one of them exceed material strength, I will consider the damage of the material.

What do you think about it?

Carmelo Barbagallo

Dear Henrik Sönnerlind, Thank you for your message. I will take a look so on principal stress criterion. In your opinion, can I related the principal stress criterion with the Rankine fracture criterion? Indeed a crack initiates when the maximum principal stress reaches the material strength. So I was thinking to calculate all principal stresses (x,y, and z) in glass and if one of them exceed material strength, I will consider the damage of the material. What do you think about it? Carmelo Barbagallo

Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 4 years ago Oct 22, 2020, 2:36 a.m. EDT

The Rankine criterion is built-in; see the attached screenshot.

-------------------
Henrik Sönnerlind
COMSOL
The Rankine criterion is built-in; see the attached screenshot.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.