Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Structure & Meshing Problem

Please login with a confirmed email address before reporting spam

I built a 3d model to study the flow characteristics of microfluidics, but I couldn't get accurate results due to differences in size. The size of the structure in the z direction is much larger than the dimensions in the x and y directions. I think it's a problem with meshing because it's hard to split the appropriate mesh. As shown, the flow direction of the fluid is along the x direction. The graphics obtained with the physics-controlled grid are strange, and sweeping the grid along the z-direction yields erroneous results. I want to know how this structure can simplify or divide the correct grid?



0 Replies Last Post Aug 18, 2019, 9:42 p.m. EDT
COMSOL Moderator

Hello Yaohuan Ding

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.