Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

converting from 2D to 3D

Please login with a confirmed email address before reporting spam

Hi

I have the following question

In a 2D axisymmetric model I apply a volume force which is dependent on r and z and it works fine

Now I wish to insert my 2D model as a cylindrical domain into a 3D model

It seems there is no way to apply the same volume force as I did in the 2D model because the

only options are Fx Fy and Fz and I can't apply the same axisymmetric force that I had in the 2D model

please advise

David

2 Replies Last Post Aug 22, 2011, 4:47 a.m. EDT
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Aug 22, 2011, 1:54 a.m. EDT
Hi

what about defining a cylindrical coordinate, or define yourself variables like r = sqrt((x-x0)^2+(y-y0)^2) (if its nicely aligned along x,y,z).

But the COMSOL coordinates system nodes allows you to easily define any orientation

--
Good luck
Ivar
Hi what about defining a cylindrical coordinate, or define yourself variables like r = sqrt((x-x0)^2+(y-y0)^2) (if its nicely aligned along x,y,z). But the COMSOL coordinates system nodes allows you to easily define any orientation -- Good luck Ivar

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Aug 22, 2011, 4:47 a.m. EDT


Hi Ivar

Thanks for your response.

I can define cylindrical coordinates but I cannot work the entire 3D model in cylindrical coordinates

The volume force node is still in cartesian and so it is impossible to define an axisymmetric force.

David
Hi Ivar Thanks for your response. I can define cylindrical coordinates but I cannot work the entire 3D model in cylindrical coordinates The volume force node is still in cartesian and so it is impossible to define an axisymmetric force. David

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.